Everything looked good the CPU was fine, temperature was good at 30c, Ram was all detected, SSD and HDD were both detected, and strangely thanks to the Bios function (GPU post)(2nd Picture included) I could see the Gpu was being detected. Then I tried the onboard HDMI finally getting a display on boot, then went into the Bios. I turned off the PC, and reseated the GPU but still no display on boot.I tried PCIe x16 slot 2, and yet still no display on boot. But after a few seconds there was no display, the Hero MB was showing the boot code A0 (IDE initialization is started) I checked the display cable and everything was plugged in. I Booted up the PC and all the RGB, and RGB accessories (GPU/fans/keyboard) turned on, and everything looked good. I installed my Nvidia RTX 2060 GPU into the PCIe x16 slot 1. Inserted the board into my case, put on the AIO cooler and connected all the necessary cables. Installation went well, moved over my CPU (Intel 8700k) into the New Hero MB. I bought this Motherboard (ASUS ROG Maximus XI Hero (Wi-Fi) Z390) to replace the MB in my prebuilt PC. Reviewed in the United States on January 13, 2020 WARNING!!! PCIe x16 Slots did not post on 1st boot. Realtek S1200A 8-channel high definition audio Intel Socket 1151 for 8th Generation Core Pentium/Celeron Processors Intel Socket 1151 for Intel Core 9000 series, 8th Generation Core i7/ i5/ i3, Pentium and Celeron processors
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |